01-08-2014, 08:41 PM
#1
User Info
The second of three razors I've recently plated.
Drilling out the pins reduces the chance of me cracking the scales and if I do it right the drill bit centers pretty much down the pin and the scales just fall off on their own without any prying etc.
For the blade I polished out the shaft and spine and redid the grind finish on the blade as the original had.
I then plated the shaft and spine wrapping the gold around the tip.
Cleaned up the scales and she was ready to be put back together again with brass pins and washers.

[Image: N5s968C.jpg]

[Image: 1yFqpfL.jpg]

[Image: coJIn6S.jpg]

[Image: yJ0CxnW.jpg]

[Image: NFjTWgV.jpg]

[Image: RU4ZWLz.jpg]

[Image: vIeDmbf.jpg]

[Image: ndgCdT1.jpg]

[Image: XBcKbcL.jpg]

[Image: oANsp35.jpg]

0 773
Reply
 01-08-2014, 08:57 PM
#2
User Info
Great work, Mark! Those scales would go so well with my All-Amber brush handle! Biggrin

78 20,953
Reply
 01-08-2014, 09:03 PM
#3
User Info
How about a pic of it, I built two brushes that would match this as well!

0 773
Reply
 01-08-2014, 09:48 PM
#4
  • geezer
  • Senior Member
  • Menomonie, Western WI
User Info
As always a very great job! You make it look original.
~Richard

8 1,191
Reply
 01-08-2014, 10:02 PM
#5
  • ben74
  • Senior Member
  • Perth, Australia
User Info
Amazing transformation!

97 17,968
Reply
 01-09-2014, 08:22 AM
#6
User Info
Thanks guys !

0 773
Reply
Users browsing this thread: 1 Guest(s)