08-25-2017, 07:39 AM
#1
  • stan
  • Active Member
  • USA
User Info
Hello,
We received the first wave of Windsor razors. However, I am not satisfied as the tops of the base plate were not polished. So we are correcting that. I know it is an area that is not seen unless dissembled. However, if you have seen photos of the limited Bronze sets we released the tops of the base plate was polished and looks nicer.
Below is a photo just to let you know. While the bottom side is polished and looks fine the top half is not. The first plates have already been sent back but the next batch being polished will be correct so the delay should not be more than a week.
I believe you will not only like their performance but will love the new look as well.
Keeping you informed.
Stan

[Image: 4lDpx6G.jpg]

0 306
Reply
 08-25-2017, 08:05 AM
#2
User Info
Stan, sending them back was clearly the right thing to do.  The question is, how did these even leave the shop doing the polishing?

50 6,264
Reply
 09-04-2017, 12:27 PM
#3
  • Jorvaljr
  • Member
  • Temple city, California
User Info
Interesting looking base plate .

3 180
Reply
Users browsing this thread: 1 Guest(s)