10-30-2019, 04:02 PM
#1
  • NJDJ
  • Senior Member
  • New Jersey
User Info
Can anyone confirm definitively whether or not a Carbon R2 handle can be used on a Wolfman WR2?

32 887
Reply
 10-30-2019, 09:43 PM
#2
  • DayMan
  • Senior Member
  • Tennessee
User Info
I’m not able to get the original Carbon handle on my Wolfman.

3 702
Reply
 10-31-2019, 02:34 AM
#3
User Info
If the Carbon Handle has a thread of M5x.08 it should fit unless the Wolfman head has a weird thread of 10/24 which I doubt. I think only the current Fatip models use a 10/24 thread although I heard Yates Machining is using it.

148 14,322
Reply
 10-31-2019, 02:39 AM
#4
  • NJDJ
  • Senior Member
  • New Jersey
User Info
Thanks for the response is guys. I've heard back from several folks and it does not work. Strange, I know.

32 887
Reply
 10-31-2019, 08:25 AM
#5
  • motto
  • Active Member
  • Copenhagen, Denmark
User Info
I recall a similar situation with the Paradigm 17-4 head which uses M5 x 0,8 thread.
The thread on the top cap is produced so thight that most of my custom handles using the same thread do not fit.
Perhaps the same here?

10 498
Reply
 10-31-2019, 11:55 AM
#6
User Info
I have the same issue with my RS-10, but not with my RS-18. That is a bit weird I must say.

0 244
Reply
Users browsing this thread: 1 Guest(s)